Software Download Page
Read this agreement fully before downloading the software
Warning carefully read the following terms and conditions before using
this software, your use of this software indicates your acceptance of this
license agreement and warranty.
This Computer program is protected by copyright law and international
treaties. This software and accompanying documentation is copyright (c)
Pencom Design, Inc. and may only be used by owners of our hardware
products. This program may be copied and distributed complete and
unaltered when sold with our hardware products by a third party, or
distributed with a larger customer's retail product which includes one of
our hardware products. This program may not be modified, reverse
engineered, in any way and must include all copyright information. Use of
this program without the accompanying hardware products beyond the evaluation period stated
below, may result is
severe civil and criminal penalties, and will be prosecuted to the maximum
extent possible under law.
Note: This software may be downloaded for evaluation purposes for a
period of 10-days without owning one of our products.
THIS SOFTWARE IS PROVIDED ``AS IS'' AND ANY EXPRESSED OR IMPLIED
WARRANTIES, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO
EVENT SHALL PENCOM DESIGN, INC. OR ITS CONTRIBUTORS BE LIABLE FOR ANY
DIRECT, INDIRECT, INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES
(INCLUDING, BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR
SERVICES; LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER
CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY
OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF
Event Control Programmer Software
This software was developed to program our 1 & 2 Channel Programmable Event Control Timers.
Version 1.00.0002 (1888 KB)
Relay Test Program Software
This software was developed to verify the operation and program additional
features (baud rate, input/output pins, etc) of our 1-2 & 8 Channel Serial Relay Boards in single board or multiple board
configurations. See the help file for operation of this software.
This version may not work properly on older 1-2 Channel relay boards
Rev A to C, and 8 Channel boards Rev A & B, contact support to obtain Version
1.00.0004 for these boards.
Version 1.00.0006 Beta1 (2264 KB) Complete rewrite of core
functions, but minor cosmetic changes. Please report any problems found
with this version.
This software was developed to control the operation of our 1,2 & 8 Channel Serial Relay
Boards in single board or multiple board
configurations using the command-line or in a window. The command-line operation will
allow the user to control the relay boards from a desktop icon in the background without
opening a window.
With this feature, a user can operate our serial relay boards
without knowing any software programming language.
When used with the built-in Windows task scheduler, these units can
be controlled as listed below.
Opening Task Scheduler and running the Command-Line Software enables you to: